Jesse Perrault

• Measured old structural parts or assemblies to determine dimensional requirements of replacements parts.
• Maintained compliance with all safety procedures from both client and employer.
• Tightened or replaced bolts and gaskets to repair leaks.
• Inspected equipment and structures to determine scope of work (SOW).
• Used hand signals to notify crane operator to lift components to specific positions.
• Dismantled equipment or devices to gain access and remove defective parts or components.
• Interpreted blueprints, sketches, and specifications for each job.
• Inspected and lubricated valves; removed, replaced, or installed components to correct operating deficiencies.
• install blinds and valves to set up and hydro test bolt ups

* Remove/dismantle paper mill in its entirety for a complete rebuild.

* Rig demo sections/rollers to crane to be loaded onto demo truck.

* Rig crane to new paper mill rollers and structural supports to crane to place into the new location of paper mill.

* Use laser Level to place machined parts/rollers into the exact loction via blueprint drawing.

* replace bearings to rollers with new replacement bearings.

• Welded in flat, horizontal, vertical, and overhead positions.
• Maintained clean working environment by consistently organizing tools and equipment, promoting workplace safety.
• Demonstrated versatility in various welding methods including MIG, Stick, and Flux Core Welding techniques.
• Fabricated shop parts directly from blueprints.
• replace roller bearing on conveyors Systems.
• 
  

* cut i beams/steel channel using oxy/acetlyn torch and plasma hand held torch

* using stick and flux core welding process to weld pipe piles and structural steel.

* RIG equipment to 500 ton crane.

• Demonstrated versatility in various welding methods including MIG, Stick, and Flux Core Welding techniques.
• Inspected welds and checked critical measurements to meet specifications.
• Operated hoists, cranes, and power tools to dismantle equipment to find and remove defective parts.
• Clamped, held, tack-welded, heat-bent and bolted component parts to achieve required configurations and positions.
• replace roller bearings on conveyor system as well as bucket Belts
• cut steel material with oxy/acetlyn torch
• fit steel beams and structural supports.
• replace drag chains
• repair high voltage frames in precip area.

*Rig to 200' piles to place into the ground.

*rig to diesel hammer/hydraulic hammer to beat piles into the ground.

*cut top of piles to grade with a oxy/acetlyn torch

*place walkway on top of piles and weld/bolt down

*place grain tower on new dock and weld/bolt/concrete.

• Replaced defective parts of machines and adjusted clearances and alignment of moving parts.
• Used hoisting and rigging equipment to move heavy machinery and equipment.
• Made repairs and modified equipment by welding, soldering and brazing to avoid production delays.
• Operated machine tools to fabricate parts during overhaul, maintenance, or setup of machineries.
• Adeptly utilized a range of hand tools, power tools, and precision measuring instruments to ensure accurate workmanship in all tasks.
• repair roller bearings and install conveyor systems